Let's be up to date bro

Ressource/configGRBL.txt

@@ -1,34 +1,34 @@
-$0=3
-$1=250
-$2=0
-$3=0
-$4=0
-$5=0
-$6=0
-$10=1
-$11=0.010
-$12=0.002
-$13=0
-$20=1
-$21=1
-$22=1
-$23=1
-$24=200.000
-$25=2000.000
-$26=250
-$27=1.000
-$30=1.000
-$31=0.000
-$32=0
-$100=640.000
-$101=640.000
-$102=640.000
-$110=3000.000
-$111=3000.000
-$112=3000.000
-$120=200.000
-$121=200.000
-$122=200.000
-$130=300.000
-$131=210.000
-$132=100.000
+$0=10 (Step pulse time, microseconds)
+$1=250 (Step idle delay, milliseconds)
+$2=0 (Step pulse invert, mask)
+$3=0 (Step direction invert, mask)
+$4=0 (Invert step enable pin, boolean)
+$5=0 (Invert limit pins, boolean)
+$6=0 (Invert probe pin, boolean)
+$10=2 (Status report options, mask)
+$11=0.010 (Junction deviation, millimeters)
+$12=0.002 (Arc tolerance, millimeters)
+$13=0 (Report in inches, boolean)
+$20=1 (Soft limits enable, boolean)
+$21=1 (Hard limits enable, boolean)
+$22=1 (Homing cycle enable, boolean)
+$23=1 (Homing direction invert, mask)
+$24=150.000 (Homing locate feed rate, mm/min)
+$25=1000.000 (Homing search seek rate, mm/min)
+$26=250 (Homing switch debounce delay, milliseconds)
+$27=2.000 (Homing switch pull-off distance, millimeters)
+$30=1.000 (Maximum spindle speed, RPM)
+$31=0.000 (Minimum spindle speed, RPM)
+$32=0 (Laser-mode enable, boolean)
+$100=635.000 (X-axis travel resolution, step/mm)
+$101=633.000 (Y-axis travel resolution, step/mm)
+$102=640.000 (Z-axis travel resolution, step/mm)
+$110=5000.000 (X-axis maximum rate, mm/min)
+$111=6000.000 (Y-axis maximum rate, mm/min)
+$112=6000.000 (Z-axis maximum rate, mm/min)
+$120=200.000 (X-axis acceleration, mm/sec^2)
+$121=200.000 (Y-axis acceleration, mm/sec^2)
+$122=200.000 (Z-axis acceleration, mm/sec^2)
+$130=300.000 (X-axis maximum travel, millimeters)
+$131=210.000 (Y-axis maximum travel, millimeters)
+$132=100.000 (Z-axis maximum travel, mi